rmkrot.blogg.se - Ithaca model 49 rear sight elevator

#Ithaca model 49 rear sight elevator manual

Moving the blade holder to the left is just as easily done. If you tap to the right your gun will shoot more to the right. To adjust for windage, gently move the rear sight blade to the right or left by tapping at the dove-tail using a wood or fiber dowel or hammer that will not mar the sight (See Figure 17). On most Model 94 sights, the entire rear sight blade holder is dove-tailed in the rear sight base. This is done by loosening the two screws that secure the blade to the blade holder and then moving the blade up or down as desired.

Move the blade and holder down to shoot lower.įor finer elevation adjustments the sight blade itself can be moved up or down.

Move the blade and holder up to shoot higher.

Adjusting the sight to make your gun shoot lower is just the opposite - move the elevator forward. To raise point of impact, use your fingers to lift up on the blade and slide the elevator rearward. Up or down elevation adjustmentsĪdjusting elevation on your Model 94 requires you to lift up the rear notch blade holder on your rifle's rear sight with your fingers and move the notched elevator either forward or backward (see Figure 16).

#Ithaca model 49 rear sight elevator manual

PLACE THE HAMMER IN THE REBOUND POSITION AND THE MANUAL HAMMER STOP INTO THE "ON" POSITION. The procedures below are for the type of open sights found on current Model 94 rifles.īEFORE MAKING ANY SIGHT ADJUSTMENTS, MAKE SURE YOUR RIFLE IS FULLY UNLOADED AND THE MUZZLE IS POINTED IN A SAFE DIRECTION. The proper procedure is to shoot a group with the sights set as they come from the factory (intermediate position on both elevation and windage), and then make incremental adjustments to move the sight blade and blade holder to position the group on your target. The style and adjustment system may vary between models and grades. All Model 94 rifles are fitted with open sights.